Refer to the "Addressing Table" provided within the lab instructions to assign addresses.
: Disable DNS lookup ( no ip domain-lookup ) and encrypt plain-text passwords ( service password-encryption ). A_feladat_1_start.pkt
Console password: line con 0 , then password cisco and login . VTY lines: line vty 0 4 , then password cisco and login . Refer to the "Addressing Table" provided within the
: On switches, configure interface vlan 1 with an IP address and no shutdown . 3. Routing and Connectivity VTY lines: line vty 0 4 , then password cisco and login
: On routers, enter interface configuration mode (e.g., interface g0/0 ), set the address ( ip address [IP] [Mask] ), and enable it with no shutdown .
: If routers cannot see all networks, add routes using the ip route [Destination Network] [Mask] [Next-Hop IP] command.
Every router and switch in the topology typically requires these initial settings: