Nad Phono Preamp Pp2 Manual [iPad VALIDATED]

: Verify that the PP 2 is connected to a standard Line-Level input and not a Phono input on your receiver. Phono Preamplifier PP 2 - HiFi Gear

: Ensure all equipment is turned off and the PP 2 is disconnected from its power supply. Connect Turntable : Nad Phono Preamp Pp2 Manual

: Connect the external 24V power supply to the PP 2 and plug it into a wall outlet. A green LED on the front panel indicates the unit is powered. 2. Technical Specifications : Verify that the PP 2 is connected

: Use RCA cables to connect the PP 2 Output to a Line-Level input (e.g., CD, AUX, Tuner) on your receiver. A green LED on the front panel indicates the unit is powered

The PP 2 utilizes high-quality components and a 24V power supply for enhanced musical dynamics and stability. Moving Magnet (MM) Moving Coil (MC) Gain at 1kHz Input Sensitivity 3.5mV (ref. 200mV output) 0.2mV (ref. 200mV output) Signal-to-Noise Ratio 80dB (A-weighted) 78dB (A-weighted) RIAA Accuracy ±0.3dBplus or minus 0.3 d cap B ±0.3dBplus or minus 0.3 d cap B THD (20Hz - 20kHz) Source: NAD PP-2 Specifications . 3. Troubleshooting

Check if the . If not, verify the power supply connections. Ensure the correct input is selected on your amplifier. Hum or Buzz :

Ensure the turntable's ground wire is securely attached to the PP 2 .